Use and Care Manual

In 2 seconds,pressing 2 before ″SET″ disappears
Displaying ″S-2″means setting over.
5.The way of using target height:
At any height(reset state,wrong state unable to perform this
operation),can quickly reache for the target height by 1~4 keys.
VIII.The way to change height
1.Colunm elongation
1).Operating by Handheld controller :Using″up button″ to
achieve longation operation,stopping when travel
limit.Releasing hand is the order to stop but not quickly.It
stops after a short distance.
2).Operating by telecontroller :Using″up button″ to achieve
longation operation,stopping when travel limit.Releasing
hand is not the order to stop,passing any key again will
stop,but not quickly.It stops after a short distance.
2.Colunm shortening
1).Operating by Handheld controller Using″down button″ to
achieve shorten operation,stopping when travel
limit.Releasing hand is the order to stop but not quickly.It
stops after a short distance.