Instructions / Assembly

- 16 -
The light is on, but there
is no high voltage when
shooting
A. gun switch B. electric cable and plug C.
whether the two wires on the high voltage
in the gun are firmly connected D. whether
the control board is normal
Generally, the high pressure in
the gun and the control panel in
the machine shall not be
disassembled or adjusted. If
there is a problem, please
contact the manufacturer first
and then determine the solution
High voltage regulation is
not low
Potentiometer damaged
Replace a potentiometer with a
similar shape with a resistance
of 4.7K
Weak high pressure，the
current indication is large
If the gun is in the suspended position, do
not approach any object, and the current
indication is large (more than half of the
light column), it indicates that A. Breakdown
and discharge at the front end of gun shell
B. Ponding in the gun or on the surface of
high-pressure module C. The high voltage
module is broken
Normally, the high-voltage
module will not be damaged,
but it is necessary to prevent
falling, collision and fracture,
prevent ponding on the damp
surface, and can not be
connected to other instruments
at will
Have high pressure but
no powder or very small
powder
A. The solenoid valve is broken B. Blocked
powder Road C. The powder pump is
broken D. Reverse injection of powder
feeding gas and powder distribution gas E.
No powder or little powder F. Powder
suction pipe falling off G. Non vulcanization
H. Air leak
A. Always hear the sound of
solenoid valve coil energization
without powder, indicating that
there is a problem with the
mechanical action of solenoid
valve B. Normal resistance of
solenoid valve 53
Hemp hand
There are two cases A. AC Leakage shall
be prevented from AC Leakage on the
spray room or machine room shell B. High
voltage leakage (feel it when shooting) be
sure to connect the grounding wire on the
high voltage control cabinet and the spray
room together and fully grounded