Instructions / Assembly

- 6 -
5.Do not force the Powder Coating Machine. This tool will do the work
better and safer at the speed and capacity for which it was designed.
6.Always unplug the Powder Coating System from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
7.Never leave the Powder Coating System unattended while running. Turn
the power off if you have to leave the Powder Coating System.
8.Before each use, check all nuts, bolts, and screws for tightness. Vibration
during mixing may cause these to loosen.
9.Keep the extension cord off the ground and away from water.
10.Always connect the Power Cord to a grounded electrical outlet.
11.The powder dust is flammable when floating in the air.
-Ventilate the area well.
-Verify that there are no flames or ignition source nearby.
-Control excess dust by cleaning up after each use.
-Never vacuum up the dust using a non-explosion proof vacuum cleaner.
-Never cure coated object in a gas oven as the fumes recreated can be
flammable; only use an electric oven.
-Never smoke while using the Powder Coating System.
12.Avoid electrical shock!
-Never touch the emitter (metal tip) of the Spray Gun. After use (and turned
OFF), touch the emitter to the Ground Clip to discharge it.
-Do not use the Spray Gun if you carry and use any electronic medical
devices.
-Never touch the metal object during coating.
13.Avoid powder contamination.
-Protect your lungs by using an approved dust mask.
-Never cure objects in an electric oven that is used for food also.
-Ventilate the area well.
-Wear an activated charcoal respirator when oven curing the coated object.
14.People with pacemakers should consult their physician(s) before using
this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference to or failure of the pacemaker.