Instructions / Assembly

Separating and checking contents: Separate all loose parts from packing materials and make

sure all parts are accounted for before discarding packing material. If any parts are missing, do not attempt

to assemble the Wood Lathe or plug into a power source. If pieces are missing, contact your

distributor directly.

To avoid re or toxic reaction, never use gasoline, naphtha or any highly volatile solvents.

Apply a coat of paste wax to the table and base to prevent rust. Wipe all parts thoroughly with a clean

dry cloth.

CONTENTS ON BOX:

BODY ASSEMBLY FACEPLATE HEX WRENCH

THIS MACHINE HAS BEEN ASSEMBLED AND TESTED AT THE FACTORY.

ADJUSTING BELT TENSION: The Lathe comes with the belt pre-installed. However, it will need an

adjustment prior to use.

Disconnect the Lathe from power source. Loosen and remove the hex bolt with the adjustable wrench.

Press down on the belt with your hand, the belt should move 1/2” when set properly.

ADJUSTING SPEED: Four spindle speeds of 810, 1180, 1700 and 2480

RPM are available with the lathe. Chart 1 shows which step of the pulleys the

belt must be placed to obtain four speed. Chart 2 shows the proper

speeds for the work piece.

CHART 1

CHART 2

1. Disconnect the lathe from power source.

2. Open the belt and pulley cover.

3. Loosen the motor pulley by loosening the bolts with adjustable wrench.

4. Place the “V” belt to correct position for desired speed.

5. Adjust “V” belt to proper tension and tighten the motor pulley.

NOTE: For proper belt tension, press down on the belt with your hand.

The belt should move 1/2” when set properly.

OPERATION AND ADJUSTMENTS

YSMachinery-VEVOR