Instructions / Assembly
APPLICATIONS
INSTALLATION
03
·Yacht/RV/caravan pressurized water system
·Sprayer xtures (vehicle-mounted sprayers ， electric sprayers)
·Cleaning machines Humidiers water purication,medical apparatus
·Food beverage lling & liquid transfer
·Solar water system
·Any other pressurization system
1.diaphragm pump with related accessories
2.(at least) pieces of exible, reinforced hose piping, with collapsing
strength of twice the inlet collapsing pressure(hose must be
minimum 1/2"ID)
3.stainless steel hose clamps and screws
4.screws to fasten the pump to the mounting suace
1 electrical cut o switch
1 fuse
1 screwdriver
1 strong cutting implement for tubing (if desired)Teon tape or sealant
1. The pump may be mounted in any position. If mounted veically,
the pump head should be in the down position to avoid leakage into
the motor casing in the event of a malfunction.
2. Secure the feet, but do not compress them. Over tightening the
securing screws may reduce their ability to dissipate noise and
vibration.
3.The inlet and outlet hoses must be 1/2" (13 mm) ID reinforced
hoses. The diameter of branch and individual supply lines from the
outlet should be no smaller than 3/8" (10 mm).
4. Plumb the system using high pressure (2 x pump rating), braided,
exible tubing to minimize vibration/noise.
5.Do not apply inlet pressure in excess of 30psi. In general, t to
avoid any inlet pressure completely.
6.Avoid any kinks or ttings which could ca use excessive restric-
tions.
7.Strainer should be attached to the inlet side.
8.The ttings must be secured to avoid leakage
9.Use clamps at both ends of the hose to prevent air leaks into the
water line.
Materials
Setup