Instructions / Assembly

- 12 -
-- Hold the machine with both hands.
-- Before operating the machine, make sure every fastening handle is
closed.
-- Connect the machine to the main power supply.
-- Before switching on the machine, keep the sanding head slightly away
from the work surface.
-- Start the machine for necessary sanding work.
Operate the machine with short length in narrow and awkward area.
Run the machine with medium length for higher walls.
Use the machine with longest length for ceilings.
-- Do not over-press machine so that to avoid overloading! Press with
proper pressure for better grinding effects. Good grinding effects and
quality are mainly decided by choosing the right abrasive material.
--Once finishing the sanding task, switch off the machine.
8. CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always
store your power tool in a dry place.
If the supply cord is damaged,it must be replaced by the manufacturer,its
service agent or similarly qualified persons in order to avoid a hazard. If a
fault can not be rectified, return the mixer to an authorized dealer for repair.
Cleaning
Keep the safety devices, ventilation slots and Motor housing as free of dirt
and dust as possible. Clean the unit by rubbing it with a clean cloth or blow
it clean using low-pressure compressed air.
-- We recommend that you always clean the unit immediately after using it.
-- Clean the unit regularly by rubbing it with a damp cloth and a little soft
soap. Do not use cleaners or solvent these will attack the plastic parts in
the unit. You must also ensure that water cannot get into the inside of the
unit.
Carbon brushes