Instructions / Assembly
Table Of Contents
- DRYWALL SANDER
- OPERATING MANUAL
- Model: ZS180-DL
- 2.SPECIEICATIONS
- 3.SAFETY INSTRUCTIONS
- 4.GENERAL SAFETY RULES
- 5.PRECAUTIONA ON USING DRYWALL SANDER
- 6.HOW TO USE DRYWALL SANDER
- Before Initial Operation
- 6.1 How to Operate
- -- Insert the hose [1-1/1-2] into the dust access
- -- Tighten the side handle [1-3] by turning it ;
- 6.2 Electronic Control
- This machine has the characteristics as below：-- L
- -- Adjustable Speed [1-5]
- Adjust the speed from 1200-2300rpm by turning the
- Attention: Only install the specified sanding pad
- 6.8 Suction power adjustment [ 1-10 ]
- 7.Operate the Machine
- -- Do not control the machine’s head.
- 8.CARE AND MAINTENANCE
- If the supply cord is damaged,it must be replaced
- 10.LABELS ON YOUR TOOL (if any)
- 14 -
For your own safety, never remove parts or accessories of the electric tool
during operation. In case of fault or damage have the electric tool repaired
only by a specialist workshop or by the manufacturer.
10. LABELS ON YOUR TOOL (if any)
For your personal safety, READ and UNDERSTAND before using.
Save This Instruction For Future Reference
Always Wear Ear Protection With This Tool
Always Wear Eye Protection With This Tool
Always Wear a breathing Mask With This Tool
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Manufacturer: Ningbo Haq Tool Co.,Ltd
Address：No. 8 Jinfeng Road, Econbmic Development Zone, Yuyao
City, Zhejiang, P.R.China.
Made In China
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
n
o
No load speed
/min or min
-1
Revolutions or reciprocation
per minute
Class ll tool
To reduce the risk of injury,
user must read instruction
manual
Wear Ear Protection
Wear Eye Protection