Instructions / Assembly
Table Of Contents
- DRYWALL SANDER
- OPERATING MANUAL
- Model: ZS180-DL
- 2.SPECIEICATIONS
- 3.SAFETY INSTRUCTIONS
- 4.GENERAL SAFETY RULES
- 5.PRECAUTIONA ON USING DRYWALL SANDER
- 6.HOW TO USE DRYWALL SANDER
- Before Initial Operation
- 6.1 How to Operate
- -- Insert the hose [1-1/1-2] into the dust access
- -- Tighten the side handle [1-3] by turning it ;
- 6.2 Electronic Control
- This machine has the characteristics as below：-- L
- -- Adjustable Speed [1-5]
- Adjust the speed from 1200-2300rpm by turning the
- Attention: Only install the specified sanding pad
- 6.8 Suction power adjustment [ 1-10 ]
- 7.Operate the Machine
- -- Do not control the machine’s head.
- 8.CARE AND MAINTENANCE
- If the supply cord is damaged,it must be replaced
- 10.LABELS ON YOUR TOOL (if any)
- 3 -
Read through these operating instructions carefully before using the
appliance. Become familiar with the functions and method of operation.
To ensure proper operation,always maintain the appliance according to
the instructions. The operating instructions and associated documents
should always be kept close to the appliance.
When using power tools, you must observe the following basic safety
precautions in order to ensure protection from electric shocks, injury and
fire. Read and follow all the instructions before using this power tool. Look
after the notes on safety.
Always check if your mains voltage corresponds with the value on
the type plate.
The machine has been double-insulated in accordance with
EN60745: therefore, an earth wire is not necessary
USE CORRECT SUPPLY VOLTAGE: The power supply voltage must
match the information quoted on the tools identification plate .
USE PROPER EXTENSION CORD: Only use an approved extension
cable that is suitable for the machine's power. The cord must have a
diameter of at least 1.5mm2. When the extension cable is on a reel, unroll
the cable in its entirety
SWITCH OFF THE MACHINE IMMEDIATELY IN CASE OF:
1.Malfunction in the mains plug, power cable or damaging of cable.
2. Broken switch.
3.Smoke or stench of scorched insulation.
4. GENERAL SAFETY RULES
WARNING! Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric
shock, fire and/or serious injury .
Save all warnings and instructions for future reference .
The term "power tool" in the warnings refers to your mains-operated
(corded) power tool or battery-operated (cordless)power tool.