Instructions / Assembly

Table Of Contents

Wire Stripping Machine

User Manual

Wire Stripping Range: Φ2mm~ 42mm

Measurement:L90cm ×W42cm × H61cm

Weight

：

80kg

Please note that there will be a little bit errors in actual use

1.Push the switch up to turn the motor on, check whether the machine work

well. Make sure there is no people on the output side of the machine.

Comparing the cables/wires’ diameters with the feeding slots on the machine,

feeding the cables/wires one piece at one time. Before feeding the

PAGE 1
Wire Stripping Machine User Manual Wire Stripping Range: Φ2mm~ 42mm Measurement:L90cm ×W42cm × H61cm Weight：80kg Please note that there will be a little bit errors in actual use 1.Push the switch up to turn the motor on, check whether the machine work well. Make sure there is no people on the output side of the machine. Comparing the cables/wires’ diameters with the feeding slots on the machine, feeding the cables/wires one piece at one time.
PAGE 2
cables/wires, please cut off the head of the cables/wires, to avoid gaps caused to the blades. 2.On the output side, if the cuts on the cables/wires are too deep, please check below points: ①、 Please adjust the handles on the input side, screw down or loose them. (M12 handles) ②、 Check whether the cables/wires on the right position as you feeding them. ③、 Make sure the blades are sharp, if not, polish them with the oil stone 3.