Instructions / Assembly

cables/wires, please cut off the head of the cables/wires, to avoid gaps
caused to the blades.
2.On the output side, if the cuts on the cables/wires are too deep, please
check below points:
①、
Please adjust the handles on the input side, screw down or loose
them. (M12 handles)
②、
Check whether the cables/wires on the right position as you
feeding them.
③、
Make sure the blades are sharp, if not, polish them with the oil
stone
3.On the output side, if see the plastic(PVC)has been stripped, but the copper
wires can not been disgorged,please check below 4 points:
①
polish the axis of the upside with the oil stone
②Check whether the springs are loose, if yes, screw down to make
them tighten
③
The diameter of the cables/wires are too small, please adjust the
space between the two axises to 0.3-0.6mm.
④
If the cables/wires you want to strip are hot, also can not get the
copper wires stripped out.
4.If the cables/wires were blocked in the axises, please check below
①、
If the springs on the press wheels are too tight,loose them.
②、
There are too much oil on the cables/wires, please wipe it.
5.If see the blades tilted :
①
Check whether the center adjuster was loosed.
②
centering adjustment and adjust the screws of two sides of it.
Make sure the cables/wires’ diameter are similar with the feeding holes,
large cables/wires in large feeding holes, small cables/wires in small feeding
holes, flat cables/wires in flat feeding holes.
This product comes with the following items: manual, gloves and oil plug