Use and Care Manual

OPERATING INSTRUCTIONS
TIPS & HINTSIONS
06
Before using the appliance for the rst time, peel o any promotional
materials and packaging materials, and check that the cooking plates are
clean and free of dust. If necessa, wipe them over with a damp cloth.
Spread over with an absorbent kitchen towel and wipe o any excess oil.
When your appliance is heated for the rst time, it may emit slight smoke
or odor, which is normal for many heating appliances, and will not aect
the safety of your appliance.
1.Place the
machine on a clean, d, level suace near a plug base outlet.
2.Plug the cord into the wall outlet.
3.The user should place the oil on the half fer when in use.
4. Turn on the power switch (SC-82 has no power switch), and the green
indicator light will be on while power is supplied to the oven. Turn the
temperature knob clockwise to adjust the temperature to the desired
temperature. At the same time, the red indicator light is on, indicating that
the electric heater begins to heat up and the temperature of the oil stas
to rise.
5. When the temperature rises to the desired level, the heat controller will
automatically cut o, while the red indicator light goes out and the electric
heater stops heating.
6. When the temperature is slightly lower, the heat controller will
automatically energize, the red indicator light and the green indicator light
will be on, the electric heater will work again and the temperature will rise.
7. After nished, for safety, please turn the temperature knob
counterclockwise to the limit position and cut o the power.
NOTE: It works in this way repeatedly in order to make sure temperature is
ceain in a range.
1.Cover is designed for keeping warm and clean. When user put on
cover,user should make sure there is no water on it in case of water draws
into pot and hot oil splashes.
2.Enclosed special basket is used for fing small piece of food. There is a
hanger and a handle on the basket. Put basket in oil when producing.
After nishing, hang up the basket and lter out the excess oil.
3. The back plate is designed to protect the electric heating tube. When
fing food, the back plate must be placed in the oil pan.
4.The tap can be used to drain the cooling oil, but please ensure that the
tap is TURNED OFF when the power is turned on.---ONLF FOR SC-102V
NOTE: Each fer with a temperature range of 50-200°C (122°F-392°F) has
an "overheat reset protection button" which will function to protect the
machine when the temperature is higher than the set value. When used
again, the user should press the protection button to reset it and then the
user can use it normally.