Use and Care Manual

- 12 -
Please use the food detergent and cleaning brush to clean the parts that
have been dismantled (refer to the product structure drawing), especially
the groove of the O-ring should be thoroughly cleaned.
Note: Please do not damage or lose parts during operation; do not use hot
water or dish washing detergent to clean the resin parts, otherwise it may
cause deformation; please do not soak the parts in the detergent for more
than 30 minutes, otherwise it may cause deterioration. For those parts that
are prone to dirt, please wash them carefully. The blade is
very sharp, please be careful not to scratch your hand.
Assembly Method of Parts
1）Assembly of the square shaft and bellows of the agitator, refer to (Figure
I) to fit the bellows into the square shaft.
Figure I
Rotate the square shaft after inserting the freezing cylinder to make it align
the inner square hole.
2）Install the stirrer on the machine, refer to (Figure J) After inserting the
freezing cylinder, rotate the stirrer to make it align the square shaft and
press the stirrer resilience, it has been determined whether it is installed in
place.
Figure J