Use and Care Manual

- 16 -
3）Press the wash button again and stir for about 5 minutes before draining
the cleaning solution.
4）Please wash with hot water for 2-3 times and stop.
5）Use a cleaning brush to clean the chute discharge port.Carefully clean
the liquid level sensor with a clean cloth and a cleaning brush.If the
cleaning is not clean, sometimes the material shortage alarm will not
work. Please remove the mixing blade and clean the rotating shaft and the
head with a clean cloth. Use a cleaning brush to thoroughly clean the
groove inside the rotating shaft. Wipe the tank with a clean cloth.
II.Washing and Unloading Parts
Turn off the power supply, screw out the four nuts of the discharge valve,
and remove the discharge valve assembly;
Pulling out the handle fixing pin, handle, valve rod and sealing ring in the
discharge valve assembly in sequence;
The agitator is withdrawn from the freezing cylinder; the parts are
disassembled to the minimum unit and cleaned.
Reinstall the cleaned parts following the opposite steps to remove.
III.Body Cleaning and Maintenance
The control switch power must be turned off before cleaning the body.
Wipe with a dry, soft cloth. If the soil is dirty, use a warm towel sprayed with
food detergent to remove the stain and wipe off the remaining detergent.
The lower part of the machine and the base are also susceptible to
contamination. Please clean it.
Regarding the drain pipe, the drain pipe is connected from the inside of the
water tank and inside the machine. If the drain pipe has liquid such as raw
materials, it may be caused by a defective motor shaft in the deep part of
the freezing cylinder, so please contact the store or maintenance personnel
who purchased the product.
Note: Please do not use polishing powder, gasoline, hot water, etc.,
otherwise it will damage the outer surface of the machine.
Please do not use water directly to avoid leakage or accidents.
If the power cord is damaged, do not use it. Please check it 1 or 2 times a
month . To check if there is any damage.