Instructions / Assembly

ASSEMBLY & ADJUSTMENTS

1. Place a workpiece on the table.

2. Turn the laser switch (Fig. 15 - 1) to the ON position.

3. Lower the drill bit to meet the workpiece (Fig. 16 - 2). The two laser

lines should cross where the drill meets the workpiece.

4. If the laser needs to be adjusted:

a. Using the included 3 mm hex key, turn the laser adjustment set

screws (Fig. 15 - 3) counterclockwise. There is one of each side

of the head.

b. Rotate the laser light housing (Fig. 15 - 4) until the two laser

lines intersect where the drill meets the workpiece.

5. Re-tighten the adjustment set screws (Fig. 15 - 3).

Fig. 15

Fig. 16

SPINDLE RETURN SPRING (FIG. 17)

The spindle is equipped with an auto-return mechanism. The main

components are a spring and a notched housing. The spring was properly

adjusted at the factory and should not be readjusted unless absolutely

necessary.

1. Unplug the drill press.

2. Place a screwdriver into the loop (Fig. 17 - 1) to hold the spring in

place.

3. Loosen the two housing nuts (Fig. 17 - 2) approximately 1/4" (6 mm).

Do not remove the nuts from the threaded shaft. Do not allow the spring

or spring housing to slip out of control.

4. While ﬁrmly holding the spring housing (Fig. 17 - 3), carefully pull

spring housing out until it clears the raised stop (Fig. 17 - 4).

5. Turn the housing so that the next notch (Fig. 17 - 5) is engaged with

the raised stop (Fig. 17 - 4).

• To increase the spindle return tension, turn the spring housing

counter-clockwise.

• To decrease the tension, turn the spring housing clockwise.

Fig. 17