Instructions / Assembly

ASSEMBLY & ADJUSTMENTS

6. Tighten the two housing nuts. Do not overtighten the two nuts. If

the nuts are tightened too much, the movement of the spindle and feed

handles will become sluggish.

ANGULAR “PLAY” OF THE SPINDLE (FIG. 18)

Move the spindle to the lowest downward position and hold in place. Try

to make the spindle revolve around its axis while also moving it with a

side motion. If there is too much “play”, proceed as follows:

1. Loosen the outer nut (Fig. 18 - 1) about 1/8 inch.

2. Without obstructing the upward and downward motion of the spindle,

turn the screw (Fig. 18 - 2) clockwise to eliminate the “play.”

NOTE: A little bit of “play” is normal.

3. Tighten the lock nut (Fig. 18 - 1).

Fig. 18

NOTE: Adjustments for

the correct function of

your drill press return

spring have been done by

the factory. Please do not

modify them. However,

prolonged use of the drill

press may make some

readjustments necessary.

DRILL PRESS ON / OFF SWITCH (FIG. 19)

1. To turn the drill press ON, insert the yellow safety key (Fig. 19 - 1)

into the switch housing (Fig. 19 - 2). As a safety feature, the switch

cannot be turned ON without the safety key.

2. Flip the switch upward to the ON position.

3. To turn the drill press OFF, ﬂip the switch downward.

4. To lock the switch in the OFF position, remove the safety key

(Fig. 19 - 1) from the switch. Store the safety key in a safe place away

from the reach of children.

Fig. 19

LIGHT & LASER LINE ON/OFF SWITCHES (FIG. 19)

The light switch (Fig. 19 - 3) is located on the lamp cover.

The laser switch (Fig. 19 - 4) is located below the ON/OFF switch on

the right.