Instructions / Assembly

ASSEMBLY & ADJUSTMENTS
Fig. 20
POSITION THE TABLE AND WORKPIECE (FIG. 20)
Always place a piece of backup material (Fig. 20 - 1) (wood, plywood,
etc.) on the table underneath the workpiece (Fig. 20 - 2). This will
prevent splintering on the underside of the workpiece as the drill bit
breaks through. To keep the material from spinning out of control, it
must contact the left side (Fig. 20 - 3) of the column as illustrated, or
be clamped (Fig. 20 - 4; not included) to the table.
NOTE: For small workpieces that cannot be clamped to the table, use a
drill press vise (not included). The vise must be clamped or bolted to
the table to avoid injury.
1
2
3
4
18