Instructions / Assembly

02
In order to assemble the zip wire correctly and safely, the following height requirements
need to be followed. One end of the cable must be mounted at a higher level than the
other end. These heights are dependant on the height of the user and the distance
between the fixing points. In order to determine the right heights, the following steps
must be.
FOLLOWED:
Measure the height of the user. If there is more than one user, and the difference in
height is less than 15 cm, use the height of the tallest user. If the difference is more
than 15 cm, the zip wire needs to be adjusted every time the user’s height is outside
the specified range.
Add 75 cm to the measured height of the user and mark this point on the tree or
construction frame.
Measure the distance between the 2 fixing points. Determine the corresponding
height in the following table and mark this height on the tree / construction at the
other side.
01.
02.
03.
Height
user
Height highest fixing point according to the following distances
between the 2 fixing points (y)
Height lowest
fixing point (x)
18,5m
2,6m
2,75m
2,9m
3m
3,2m
15,5m
2,45m
2,6m
2,75m
2,9m
3m
12,5m
2,3m
2,45m
2,6m
2,75m
2,9m
21,5m
2,75m
2,9m
3m
3,2m
3,35m
1,2m
1,4m
1,5m
1,7m
1,8m
HIGHEST
2m
2,1m
2,3m
2,45m
2,6m
24,5m
2,9m
3m
3,2m
3,35m
3,5m
INSTRUCTIONS FOR CABLE HEIGHT
MINIMUM
RIGHT
WRONG