Instructions / Assembly

· Do not use the HOLD function to measure unknown voltage. After HOLD is

turned on, the display screen will not change when different voltages are

measured.

· Measure a known voltage to determine whether the instrument operates

normally.

· When measuring, the correct function and range gear must be used.

· Do not use the instrument around explosive gas and steam or in humid

environment.

· Do not use damaged probes. Check whether the insulation of the probe is

damaged, whether there is exposed metal or signs of wear. Check the continuity

of the probes.

· When measuring, please connect the neutral wire or ground wire first, and then

the live wire; when disconnecting, please cut off the live wire first, and then

disconnect the neutral wire and ground wire.

· When measuring, please hold your fingers behind the probe finger protector.

· Please disconnect the probe from the measured object before opening the back

cover of the instrument.

· Do not use the instrument in an environment that exceeds the measurement

category (CAT) rating of the lowest rated single element in the instrument, probe

or accessories.