Use and Care Manual
Table Of Contents
- Before using the electrical appliance, the followi
- 1.Read all instructions.
- 2.Do not operate any appliance with a damaged cord o
- 4. Always disconnect the blender from the supply i
- 5. Do not let cord hang over edge of table or hot
- 13.In the process of using the appliance, it is neces
- 14.Switch off the appliance and disconnect from suppl
- 15.Appliances can be used by persons with reduced
- 1. Insert the blending rod into the threaded inner
- 2. Tighten the lock nut to fix the blending rod fi
- USING YOUR BLENDER
- Before the first use, clean the blender according
- IMPORTANT: Blades are very sharp; handle them with
- Note:
- 9 -
REMOVAL/INSTALLATION OF BLADE ASSEMBLY
1. Align the blade assembly with wrench 1 and insert into it.
2. Align the blending head slot with wrench 2 and insert into it.
3. Unscrew clockwise to remove the blending rod.
FAULT ANALYSI
Fault
Phenomenon
Cause Analysis
Exclusion Methods
Indicator light is
not on
The power cord is not
plugged in.
1.Check the power cord to make
sure it is plugged in.
Indicator Light
on Product
Inoperative
1.Long working hours,
motor overheat
protection.
2.The machine itself is out
of order.
1.Wait an hour before reusing
2.Send to after-sales service
department.