Use and Care Manual
Table Of Contents
- Before using the electrical appliance, the followi
- 1.Read all instructions.
- 2.Do not operate any appliance with a damaged cord o
- 4. Always disconnect the blender from the supply i
- 5. Do not let cord hang over edge of table or hot
- 13.In the process of using the appliance, it is neces
- 14.Switch off the appliance and disconnect from suppl
- 15.Appliances can be used by persons with reduced
- 1. Insert the blending rod into the threaded inner
- 2. Tighten the lock nut to fix the blending rod fi
- USING YOUR BLENDER
- Before the first use, clean the blender according
- IMPORTANT: Blades are very sharp; handle them with
- Note:
- 7 -
IMPORTANT: Blades are very sharp; handle them with care. Ensure that the
hand-held blender is unplugged from the power outlet before installing or removing
attachments.
OPERATION METHOD
GETTING STARTED AND STOPPED
1. Check that the power button (3) is released.
2. Install the blending rod.
3. Connect the main unit to the power source.
4. Press the safety button (1) and proceed to the next step within 5s. If the
unlocking fails after 5s, press the safety button (1) again.
5. Press the power button (3) to start the hand blender (working time per cycle≤ 3
minutes, interval time between two cycles≥ 1 minute).
6. Release the power button (3), and the machine will stop automatically.