Use and Care Manual
Table Of Contents
- Before using the electrical appliance, the followi
- 1.Read all instructions.
- 2.Do not operate any appliance with a damaged cord o
- 4. Always disconnect the blender from the supply i
- 5. Do not let cord hang over edge of table or hot
- 13.In the process of using the appliance, it is neces
- 14.Switch off the appliance and disconnect from suppl
- 15.Appliances can be used by persons with reduced
- 1. Insert the blending rod into the threaded inner
- 2. Tighten the lock nut to fix the blending rod fi
- USING YOUR BLENDER
- Before the first use, clean the blender according
- IMPORTANT: Blades are very sharp; handle them with
- Note:
- 8 -
Continuous operation instruction
After completing steps 1-5 above, proceed to the following steps:
1. Press the lock button (4) when the power button (3) is pressed down, and the
red indicator lights up.
2. Release the power button (3) at this time, the hand blender will continue to work.
3. Press the power button (3) again, and the appliance stops, and the red indicator
is turned off
Speed adjusting instruction
After completing steps 1-5 above, proceed to the following steps:
1. Rotate the speed knob (2) to the desired speed setting
NOTE：
In order to better control the hand blender, it is recommended to hold the handle
and the bottom of the body. In addition, tilting the machine at a slight angle is
recommended to prevent the bell-shaped housing from touching the bottom of the
container. The ingredients in the container shall not exceed the MAX height of
the blending rod. Avoid splashing the food into the vent holes of unit body during
blending.
CLEANING AND MAINTENANCE METHODS
1. Unplug the appliance and remove the detachable blending rod.
2. Wash the detachable blending rod under running water without using an
abrasive cleaner or detergents. After cleaning the detachable blending rod, place it
upright so that any water that may have gotten in can be drained.The blending rod
is a dishwasher-safe component.
3. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning,
as an electric shock may occur.
4. Dry thoroughly.
QUICK CLEANING
Between processing tasks, hold the hand-held blender in the container half filled
with water and turn on for a few seconds.
CAUTION: Blades are very sharp; handle them with care.