Unit installation

9
Setting the Range
FL-22HD
The FL-22HD has 6 depth ranges. Zero to 10’, 20’, 30’, 40’, 50’, and 60’. To interpret
depth, you multiply the displayed reading by the range multiplier.
In normal mode, read the yellow scale numbers and, if set beyond the 10’ range,
multiply by the range setting selected. In the figure above, if the range is set to “x2”.
The depth would then be 16 feet (8’ x 2), and there is a sh is at 8 feet (4’ x 2).
If the range control was set to “x3”, the bottom would be interpreted as
24 feet (8’ x 3) and the sh would be at 12 feet (4’ x 3).
Normal mode selected
Reading the depth is the same in LP (Low Power) mode. Reading the depth in
AZ (Auto Zoom) or BL (Bottom Lock) mode is discussed on page 15.