Manual

9/9/12 Vexilar P100 Carrying Case Assembly Instructions
1/2vexilar.com/pages/support/instructions/instructions_p100.php
P100CarryingCaseAssemblyInstructions
Locate the base section and set it down
onasturdysurfacewiththeflatsideup.
Now,locatethehandlesectionandinsert
it into the base as shown. Slide the
handle down into the base until it snaps
intoplace.
Locate the rubber transducer holder and
insert it into the large hole in the base.
Start at one side and work it around so
the groove in the holder fits over the
plasticedgeofthehole.
Set your battery into the battery tray in
the base. The tray is made to fit a
standard size, sealed lead acid or gel
cell, battery. Locate the cableties. Insertone of them, starting from the
bottomcenterofthebase,upthroughtherectangularhole,thenthrough
the rectangular hole in the handle. Now, go over the top of the battery,
down through the remaining hole in the base, and into the head of the
cable tie. Do the same with the other tie. Using a pair of pliers, pull the
endsof the ties untiltheyaretight. The battery shouldnotmove around
atall.
If your mountinga Vexilar FL series
depth finder, you can use the
providedplasticfastenerstoattachit
to the base. Simply push the
fasteners down through the bracket
and into the base. They will snap
intoplace.
Pushon terminals are also provided
to connect the units power cord to
the battery. Cut the cord to the
proper length and crimp the
terminals onto the power cord.
Route the wires through one of the
roundholesinthehandle.Pushtheterminalsontothebatteryposts.Make
sureyouconnectwiththeproperpolarity.
TipYoucan wrap the extratransducercablearoundthe unitsmounting
bracketandthecarrycasehandle.


