User Guide

u-center-User Guide
UBX-13005250 - R18

Production Information 5 u-center Menus and Windows
Page 21 of 67
5.1.1.5 Receiver
Figure 15: Receiver menu entries
Function Description Shortcut /
Toolbar icon
Port Defines the port u-center connects to. The list is generated automatically using the
enumeration method under Tools -> Preferences -> Generic -> Serial ports. The currently
used port will be indicated.
Disconnect Disconnects from a connected receiver.
COMx Connects to COMx with the current baud rate. Ctrl+[1...9]
(if available)
Network connection Connects to a receiver through network.
Baud rate Defines the baud rate of the communication. The list is predefined and cannot be changed.
The currently set baud rate will be indicated.
Location API Connects to the receiver using the Location API of Windows 7 onwards.
Sensor API Connects to the receiver using the Sensor API of Windows 7 onwards (the USB Sensor driver
is required in this case).
NTRIP Server/Caster Enables u-center to act as a NTRIP server.
NTRIP Client Enables u-center to act as a NTRIP client.
Autobauding Enables or disables autobauding for the current communication with the receiver.
Debug Messages Enables all debug messages in the receiver. Can be requested by the u-blox support.
Generation Defines the generation of the attached u-blox GNSS receiver. u-center also tries to detect
automatically the correct generation.
Protocol Filter Sets the message filter against versions of protocol specification.