User Guide

u-center-User Guide
UBX-13005250 - R18

Production Information 6 NTRIP
Page 52 of 67
13.Enter the altitude in meters in floating point or integer format. See position k.
14.Enter the geoid separation in meters in floating point or integer format. See position l.
15.Click on "OK" to start receiving correction data.
6.2 NTRIP Server/Caster
The u-center NTRIP caster is able to accept requests from NTRIP compliant clients and send them RTCM correction
data. This is implemented according to NTRIP standard version 1. The server part is not implemented according
to the standard but we are currently supporting one mount point which gets data from direct connection to
the receiver.
Perform the following steps to set up the caster:
1. Establish the communication between u-center and the device (see also Connect to the receiver).
2. Open NTRIP server/caster settings dialog by clicking on Receiver -> NTRIP Server/Caster...
Figure 49: NTRIP server settings dialog
3. Enter the port which will be used by the NTRIP caster. See position a.
4. Check "Enable authentication" if you want to enable basic authentication on your caster. See position b.
5. Enter the username which will have to be provided by the clients (only if you enabled authentication under
4). See position c.
6. Enter the password which will have to be provided by the clients (only if you enabled authentication under
4). See position d.
7. Enter the name for the mount point. See position e.
8. Enter the identifier for the mount point e.g. name of the city next to mount point location. See position f.
9. Enter the country code in ISO 3166 for the mount point. See position g.