WARNING DO NOT USE UNTIL ALL INSTRUCTIONS REGARDING SAFETY HAVE BEEN READ.
® TM Your new SENTRY by VFORCE combines solid durability protection and comfort in a unibody constructed mask with the thickest shell in it’s class. This mask protects from both 50cal and 68cal paintballs. TM The renowned and reliable ARMOR lens design ensures distortion-free vision, enhancing your rapid target-acquisition efficiency and overall safety.
WARNING Read and follow carefully all instructions and warnings contained in this manual. Failure to observe all instructions and warnings could lead to severe or permanent injuries. Remember that your mask cannot offer protection in all situations WARNING This Vision System provides Extended Coverage as defined in ASTM standard F1979.
TABLE OF CONTENTS Fitting 4 Mask and Lens Care 5 Lens Removal 6 Lens & Eye Foam Removal 7 Eye Foam Installation 8 Lens Installation 9 Chip Strap Installation 10 WARNING Wear your paintball protective Vision System at all times when playing, practicing or target shooting. WARNING Before each game, breathe on the inside surface of the lens. If it fogs up: before using your mask - replace the lens or treat it with VForce Anti-Fog Solution.
Sentry CLEANING ANTI-FOG TREATMENT STORAGE Sentry
SENTRY Push inner temple clip firmly upwards with your thumb while holding top of mask securely with both hands. Once clip slides off repeat step on other side of mask. Remove fastening clips from both sides of lens by pushing each clip from the inside of mask with your fingers releasing and sliding the clip from under the lens with your free hand. WARNING Check lens before each and every use. Replace the lens after one year of use even if it seems to be perfect.
LENS REMOVAL SENTRY 5 4 Press on the fastening tab (edge of lens temple area) to dislodge the lens from mask. Repeat step on opposite side and remove lens from mask. EYE FOAM REMOVAL Once all clips, fasteners and lens are removed the Eye Foam can simply be popped out by pulling it from it’s support slots. WARNING Use only lenses specifically designed for this vision system model.
EYE FOAM INSTALLATION SENTRY 1 2 Angle EyeFoam from support slot on one side then snap into opposite support slot. When secured you will hear audable “click” sound. Insert EyeFoam by resting one side first on support slot.
LENS INSTALLATION SENTRY 1 Insert new lens making sure that both fastening tabs are fully inserted and securely in place. Ensure that both upper positioning tabs are inserted in their respective slots. 2 Reinsert fastening clips by sliding and snapping them under the lens temple tabs. WARNING Ensure that the lens is firmly in place before wearing the mask. Do not make and modifications to your mask. Use only accessories that have been approved for your Sentry mask by VForce.
CHIN STRAP INSTALLATION SENTRY 1 2 To properly fasten the buckle insert the “male” prongs into the “female” portion until you hear an audible “click”. Adjust strap to fit snugly under your chin. Unfastening the buckle is accomplished by squeezing the right and left edges of the “male” prongs until they are automatically ejected from the “female” portion. WARNING NEVER play a game of paintball without the chip strap securely attached to the mask.
This model is certified by: SAI Global Assurance Services Ltd. Partis House, Ground Floor, Davy Avenue, Knowlhill, Milton Keynes MK5 8HJ, United Kingdom - Notified Body Number: 2056 VFORCE VISION SYSTEMS 6000 Kieran, St-Laurent, Quebec, Canada www.vforce.
