User`s manual

Hardware Installation

2.4 Jumper Settings for Wake-On-PS/2 Keyboard

Wake-On-PS/2 Keyboard - Jumper JP1

The Wake-On-PS/2 Keyboard function allows you to use the PS/2

keyboard to wake up the system from the S5 state. By default, JP1

is disabled. To use this function, set JP1 to 2-3 On. “PS2KB Wakeup

Select” (“IRQ/Event Activity Detect” field) in the Power Management

Setup submenu of the BIOS must be set accordingly. Refer to

chapter 3 for details.

Warning:

1. If you forgot the password, you must power-off the system,

unplug the power cord and clear the CMOS data. Follow

the steps in the “Jumper Settings for Clearing CMOS Data”

section.

2. The 5VSB power source of your power supply must

support

≥

720mA.

2-3 On: Enable - 5VSB1-2 On: Disable - VCC

(default)

123 123