User`s manual

68
3
Award BIOS Setup Utility
IRQ/Event Activity Detect
Move the cursor to this field and press <Enter>. The following fields
will appear.
PS2KB Wakeup Select
Password To use a password to wake up the system, select
this option then press <Enter>. Enter your
password. You can enter up to 5 characters. Type
in exactly the same password to confirm, then
press <Enter>.
Important:
If you forgot the password, you must
power-off the system, unplug the power
cord and clear the CMOS data. Follow the
steps in the “Jumper Settings for Clearing
CMOS Data” section in chapter 2.
Ctrl+F1 Use the <Ctrl> and <F1> keys to wake up the
system.
Disabled Disables the Wake-On-PS/2 Keyboard function.
USB Resume from S3
Set this field to Enabled to use the Wake-On-USB Keyboard
function. This function allows you to use a USB keyboard to wake
up a system that is in the S3 (STR - Suspend To RAM) state.
Refer to “Jumper Settings for Wake-On-USB Keyboard” in
chapter 2 for more information.
VGA
When set to On, the system will respond and wake up to any
VGA activity.
LPT & COM
Select the port you would like the system to respond and wake
up when an event occurs on that por t.
HDD & FDD
When set to On, the system will respond and wake up to any
hard drive or floppy drive activity.
PCI Master
When set to On, the system will respond and wake up to any
PCI or bus master activity.