User`s manual

VCN700-LIC10/15
28
1.7.14 Serial ATA Connector (SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
SA1
SA2
 Install the Windows® 2000 Service Pack 4 or the Windows® XP
Service Pack1 before using Serial ATA.
 When using the connectors in Standard IDE mode, connect the
primary (boot) hard disk drive to the SATA1 connector.
Connect the right-angle side of
SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
SATA2
SATA1