User`s manual

VCN700-LIC10/15
40
2.2.2.9 Boot Up NumLock Status
Set the boot up Num Lock status. The options are “On” and “Off”.
Item Description
On Enable NumLock
Off Disable NumLock
2.2.2.10 Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the keyboard controller.
The commands are “Enabled” or “Disabled”. Enabling allows the typematic rate and delay
to be selected.
2.2.2.11 Security Option
This category determines whether the password is required when the sys- tem boots up or
only when entering setup. The options are:
Item Description
System
The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if the correct
password is not entered at the prompt.
To disable security, select PASSWORD SETTING at Main Menu and
then you will be asked to enter password. Do not type anything and
just press <Enter>, it will disable security. Once the security is
disabled, the system will boot and you can enter Setup freely.
2.2.2.12 MPS Version Control for OS
This option is only valid for multiprocessor motherboards as it specifies the version of the
Multiprocessor Specification (MPS) that the motherboard will use. The MPS is a
specification by which PC manufacturers design and build Intel architecture systems with
two or more processors.
MPS 1.1 was the original specification. MPS version 1.4 adds extended configuration
tables for improved support of multiple PCI bus configurations and greater expandability in
the future. In addition, MPS 1.4 introduces support for a secondary PCI bus without
requiring a PCI bridge.