User's Manual

Chapter 3
3-16
IR Transmission Delay
Set the delay mode of IR transmission/reception. Settings: Enabled and
Disabled.
UR2 Duplex Mode
Set the operating mode of IR transmission/reception. Under Full Duplex
mode, synchronous, bi-directional transmission/reception is allowed.
Under Half Duplex mode, only asynchronous, bi-directional transmis-
sion/reception is allowed. Settings: Full and Half.
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port.
Settings: 378/IRQ7, 278/IRQ5, 3BC/IRQ7 and Disabled.
Parallel Port Mode
Set the parallel port mode. To operate the onboard parallel port as Standard
Parallel Port, choose “SPP.” To operate the onboard parallel port in the
EPP mode, choose “EPP.” By choosing “ECP”, the onboard parallel port
will operate in ECP mode. Choosing “ECP + EPP” will allow the onboard
parallel port to support both the ECP and EPP modes simultaneously.
Settings are:
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
ECP + EPP: Extended Capability Port + Enhanced Parallel Port
EPP Mode Select
Select the Enhance Parallel Port mode. Settings: EPP1.9 and EPP1.7.
ECP Mode Use DMA
ECP utilises a DMA channel. This field is only available if Parallel Port
Mode is set to “ECP”. Select DMA channel for ECP use. Settings: 1 and 3.
Game Port Address
Set I./O port address for onboard game port. Settings: Disabled, 201 and 209.
Midi Port Address
Set I./O port address for onboard midi port. Settings: Disabled, 330, 300 and
290.