User`s manual

User’s Manual 27
SuperIO Device
Item Available Options:
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART Mode Select Normal
RxD, TxD Acitve Hi,Lo
IR Transmission Delay Enabled
UR2 Duplex Mode Half
Use IR Pins IR-Rx2Tx2
Onboard Parallel Port 378/IRQ7
Parallel Port Mode Normal
EPP Mode Select EPP1.7
ECP Mode Use DMA 3
․UART Mode Select
Select an operating mode for the serial port.
<Choice: IrDA, ASKIR, Normal>
․Parallel Port Mode
Set the parallel port mode.
<Choice: SPP, EPP, ECP, ECP + EPP, Normal>
28
The ENDAT-3400M System Board
3-5. Power Management Setup
The Power Management Setup allows users configuring the system to save energy
in a most effective way while operating in a manner consistent with their own style of
computer use.
Item Available Options:
ACPI function Enabled
ACPI Suspend Type S1(POS)
Power Management Option User Define
HDD Power Down Disabled
Suspend Mode Disabled
Video Off Option
Suspend -＞ Off
Video Off Method V/H SYNC+Blank
Soft-Off by PWRBTN Instant-Off
Run VGABIOS if S3 Resume Auto
AC Loss Auto Restart Off
Delay Prior to Thermal 16 Min
IRQ/Event Activity Detect Press Enter
․
ACPI Function
This function should be enabled only in operating systems that support ACPI.
Currently, only Windows® 98SE/2000/ME/XP supports this function. When this
field is enabled, the system will ignore the settings in the “Suspend Mode” and
“HDD Power Down” fields. If you want to use the Suspend to RAM function,
make sure this field is enabled then select“S3 (STR)” in the field below.
․ACPI Suspend Type
This field is used to select the type of Suspend mode.
S1(POS)
Enables the Power On Suspend function.
S3(STR)
Enables the Suspend to RAM function.
S1 & S3
If S3 state is supported by the system, by default [S3] is
automatically selected. Otherwise [S1] is selected.
․Run VGABIOS if S3 Resume
Select whether to run VGA BIOS if resuming from S3 state. This is only
necessary for older VGA drivers.
<Choice: Auto, Yes, No>