Product Manual

200 PSI FAST-FILL AIR SOURCE KIT
USER MANUAL
MOUNTING AND WIRING:
1.Disconnectgroundcablefromvehicle’sbattery.
2. Temporarily position the air source kit in the location
where it will be mounted.
3.Routegroundwiretothenegativepostofthebatteryorto
an appropriate grounding point and cut ground wire to
length as needed.
4.Mountairsourcekitattanklegmountswiththefour
 grommets,andfoursetsofbolts,nuts,washers,
 andlockingwashersprovided.Useofthreadsealant
is recommended.
5.Route3/8-inchI.D.airlinefromthe1/2-inchtankport
 toa3/8-inchcompressionttingandmakeyourairline
 connection.Tightencompressionttingnutsecurely
using a wrench.
6.Connectground(Black)wiretoacleanground,(preferablya
 negativepostofbattery)andsecurewitha
self-tapping screw.
7.Connectpositive(Red)leadwirefrompre-installed
 pressureswitchtoafuseholder(30-ampminimum).
8.Oncethekitisproperlyfusedascloseaspossibleto 
 thepowersource,connectandtestcompressorsystem
by running the compressor for a short time to build up
pressure in your air tank.
9. Once air pressure reaches preset cut out pressure of
 yourpressureswitch(165PSIcut-on,200PSIcut-off),the
compressor will shut off automatically. Inspect all air line
connections for leaks with soap and water solution. If a leak
 isdetected,theairlinemaynotbecutsquarelyorpushed
all the way in. Tighten connections if needed.