Product Manual

Excessivemoistureindischarge 1.Excessivewaterinairtank
2.Highhumidity
1.Draintank,tilttanktodrain. Draintankmorefrequently 2.Movecompressortoareawithlesshumidity, oruseairlinelter.
Compressorwillnotrun 1.Nopower,orpowerswitch
in OFF position
2.Blownfuse 3.Motoroverheats 4. Faulty pressure switch.
1.MakesurecompressorswitchisON 2.Disconnectcompressorsfrompowersource, replacefuse.(RefertoSpecicationssectionfor correctfuseamperage.) 3.Letcompressorscooloffforabout30Minutes toallowthermaloverloadswitchreset. 4.Replacepressureswitch
Thermaloverloadprotector
cuts out repeatedly
1.Lackofproperventilationor
ambient temperature too high
2.Compressorvalvesfailed
1.Movecompressortowellventilatedarea, or area with lower ambient temperature 2.Repairorreplacecompressor
Excessiveknockingorrattling 1. Loose mounting bolts
2. Worn bearing on eccentric or
motor shaft
3.Cylinderorpistonringisworn
1. Tighten mounting bolts 2.Repairorreplacecompressor 3.Repairorreplacecompressor
CAUTION: NEVER DISASSEMBLE COMPRESSOR WHILE COMPRESSOR IS PRESSURIZED.