Owner manual

(Fig. 2) Compressor

Mounting Hardware

B.MountingBolt

C.FlatWasher

D.LockingWasher

E.Nut

H.VibrationIsolator

OPERATING INSTRUCTIONS

1. IMPORTANT:AlwaysoperatethecompressoratorbelowtheMAXIMUMPRESSURERATINGof

 thecompressor.PleaserefertoApplication&SpecicationsSectionsofthismanualfordetails.

2.AlwaysobservetheMAXIMUMDUTYCYCLEoftheaircompressor.RefertoCompressor

 ApplicationandSpecicationsSectionsofthismanualfordetails.Operationexceeding

 maximumpressureratingsand/ordutycyclewillresultindamagetotheaircompressor.

3.YouraircompressorisequippedwithanAUTOMATICTHERMALOVERLOADPROTECTOR.

 Thisfeatureisdesignedtoprotecttheaircompressorfromoverheatingandcausingpermanent

 damagetoyouraircompressor.Thethermaloverloadprotectorwillautomaticallycutpowerto

 youraircompressorshouldtheinternaloperatingtemperatureoftheaircompressorriseabove

 safelevelsduringexcessiveuse.

4.Shouldatanytimeduringuse,youraircompressorautomaticallyshutsoff;donotattemptto

restart the air compressor. Turn off power and allow unit to cool for about 30 minutes. This will

 allowtheThermalOverloadProtectortoresetsoyoucansafelyresumeuseoftheaircompressor.

5.Topreventdischargeofyourvehicle’sbattery,andenhanceperformance,keepthevehicle’s

engine running while using the compressor.

6.Onlyoperatecompressorinwellventilatedareas.

7.Theuseofarelayisstronglyrecommendedforinstallationofthiscompressor,butisnotincluded.

 (40-amprelayvalueorhigher)

USER MANUAL

280C Air Compressor Kit

RELAY WIRING SCHEMATIC

Pressure Switch

Fused

12-Volt

To Ground

Compressor

(+) Lead

(Fig. 3) Leader Hose Bracket

I.HoseClamp

J.ClampReleaseTab

K.SelfAnchoringPin

REDUCER