Installation Manual

SAFETY PRECAUTIONS
1. Always inflate tires to manufacturer’s
recommended tire pressures. Exercise extreme
caution when driving with aired-down tires.
2. Never exceed 20 M.P.H. when driving with
partially inflated tires.
3. Never make sharp turns while driving with
reduced tire pressure.
4. Re-inflate tires before high speed traveling onto
roadways.
5. Only use heat-resistant, minimum 200 PSI-rated
working pressure extension hose. Some
aftermarket hoses may not be suitable for use
with this air compressor due to heat and
pressure typically generated by this type of air
compressors.
6. Use of a close-ended tire chuck will cause
excessive pressure buildup if the tire chuck is
not attached to tire valve stem while air
compressor is in operation.
7. IMPORTANT: Always use an Open-Ended tire
chuck such as the tire chuck equipped on the
Inflator/Deflator Coil Hose for tire inflation.
CAUTION: Never touch the air compressor or
fittings connected to the air compressor with bare
hands during or immediately after use. The fittings on
extension hose will become very HOT during use. If
necessary, wear heat resistant gloves to remove
extension hose from primary hose.
MAINTENANCE & REPAIRS
1. Your air compressor is equipped with a
permanently lubricated, maintenance-free motor.
Never try to lubricate the compressor.
2. Regularly clean dust and dirt from compressor
cooling fins and motor housing.
3. Only the Manufacturer or Manufacturer
authorized service agencies should perform
repairs.