Owner manual

TROUBLESHOOTING GUIDE:
Compressorwillnotrun 1. No power, or power switch
inOFFposition
2.Blownfuse
3.Motoroverheats
1.Makesurecompressor
switchisON
2. Disconnect compressor
from power source, replace
fuse.(RefertoSpecications
section for correct
fuseamperage)
3.Letcompressorcoolofffor
about30minutestoallow
thermaloverloadswitchtoreset.
Thermaloverload
protector cuts out
repeatedly
1.Lackofproperventilationor
ambient temperature is too high
2.Compressorvalvesfailed
1.Movecompressortowell
ventilatedarea,orareawith
lower ambient temperature
2. Replace compressor
Excessiveknocking
or rattling
1. Worn bearing on eccentric or
motor shaft
2.Cylinderorpistonringisworn
1.Serviceorreplacecompressor
Compressorairowlower
than normal, or cannot
pump to higher pressures
1.Wornpistonringorinletvalve 1.Serviceorreplacecompressor
PROBLEM: POSSIBLECAUSE(S) CORRECTIVEACTION
400P AUTOMATIC PORTABLE COMPRESSOR
USER MANUAL