450P AUTOMATIC PORTABLE COMPRESSOR EXTREME SERIES PART NO. 45043 IMPORTANT: It is essential that you and any other operator of this product read and understand the contents of this manual before installing and using this product.
450P AUTOMATIC PORTABLE COMPRESSOR IMPORTANT SAFETY INSTRUCTIONS: CAUTION: To reduce risk of electrical shock or electrocution: - Do not disassemble. Do not attempt repairs or modifications. Refer to qualified service agencies for all service and repairs. - Do not use this product in or area where it can fall or be pulled into water or other liquids. - Do not reach for this product if it has fallen into liquid. - Use this compressor with 12-volt DC systems only.
450P AUTOMATIC PORTABLE COMPRESSOR OPERATING INSTRUCTIONS: Please read and follow the operating instructions carefully to assure that you will enjoy the convenience and best use out of your air compressor. 1. Always operate the compressor AT OR BELOW THE MAXIMUM PRESSURE RATING of the compressor. Refer to Specifications section of this manual. 2. Always OBSERVE THE MAXIMUM DUTY CYCLE of the air compressor. Refer to Specifications section of this manual for details.
50P AUTOMATIC PORTABLE COMPRESSOR OPERATING INSTRUCTIONS (cont’d): This air compressor comes with 1/4” quick connect stud. An extension coil hose and a tire inflation gun are also included with your compressor. Each end of the extension coil hose is equipped with a 1/4” quick connect coupler. The tire inflation gun comes with a 1/4” quick connect stud, pressure gauge, rubber hose, bleeder valve and tire chuck.
450P AUTOMATIC PORTABLE COMPRESSOR SAFETY PRECAUTIONS: 1. Always inflate tires to manufacturer’s recommended tire pressures. Exercise extreme caution when driving with aired-down tires. Reinflate tires before high-speed roadway travel. 2. Never exceed 20 M.P.H. when driving with partially inflated tires. 3. Never make sharp turns while driving with reduced tire pressure. 4. Re-inflate tires before high speed traveling onto roadways. 5.
450P AUTOMATIC PORTABLE COMPRESSOR INLET AIR FILTER INSTALLATION INSTRUCTION: 1. Check to make sure air filter element is properly installed in your Inlet Air Filter Assembly 2. Remove the temporary protective red plug from compressor’s air inlet port. 3. Install inlet air filter onto compressor’s air inlet port. (Teflon tape Not Recommended). 4. Hand tighten inlet air filter. IMPORTANT: For optimal compressor performance, replace filter element periodically.
450P AUTOMATIC PORTABLE COMPRESSOR TROUBLESHOOTING GUIDE: PROBLEM: POSSIBLE CAUSE(S) CORRECTIVE ACTION Compressor will not run 1. No power, or power switch in OFF position 2. Blown fuse 3. Motor overheats 1. Make sure compressor switch is ON 2. Disconnect compressor from power source, replace fuse. (Refer to Specifications section for correct fuse amperage) 3. Let compressor cool off for about 30 minutes to allow thermal overload switch to reset.
450P AUTOMATIC PORTABLE COMPRESSOR MODEL 450P AUTOMATIC SPECIFICATIONS: Part Number: Motor Voltage: Motor Type: Max. Intermittent Pressure: Max. Duty Cycle: (Min. On/Off @ 72ºF & 100 PSI) Continuous Use @ 72ºF & 30 PSI: Max. Current Consumption: Fuse: Inline Pressure Gauge: Built-in Pressure Switch: Auto.