Specifications

SurfBeam Satellite Modem Installation and Configuration Guide
VSD-200292-02-085 Rev. A
2
-
4
13. Remove input power from the SM by unplugging the in-line power
supply from the power source.
14. Disconnect the Ethernet cable from the Support PC, and connect it
to the User’s CPE.
15. Ensure the TX and RX coaxial cables are connected to the SM.
16. Apply input power to the SM, by plugging the in-line power supply
into the power source. Observe the SM power indicator lights.
17. Turn on and boot the CPE. Observe the SM LAN indicator lights.
18. Refer to the CPE’s Operating System documentation, and configure
the CPE to automatically obtain an IP address from the DHCP
server.
19. See Figure 3-1 and refer to Table 3-1. Observe the SM front panel
indicators as the SM acquires the downstream signal, and
completes the ranging/registration process. The IP address is
automatically obtained from the Internet Service Provider (ISP).
20. After the satellite modem is installed and configured correctly, and
the CPE obtains its IP address, you are ready to surf the Internet.
Note
Figure
2
-
3
shows the
initial frequency/power
search alogrithim that is
used based on the entered
values.
Note
No special software
is required to be installed on
the users computer to
operate the SM.
Note Refer to the
documents provided with
your Internet browser to surf
the Internet.
Note The Provisioning
Process may be different
depending upon local ISP
guidelines.