Instructions / Assembly

To avoid damaging the battery
do not charge unused
(brand new) batteries
RENU-IT
TM
DIRECTIONS FOR USE
• Advanced processor control for simple plug and go operation.
• 3 battery chemistries: Alkaline, NiCd, NiMH
• 6 charging docks for charging ‘AA’, ‘AAA’, ‘9v’
• Simultaneous charging of mixed sizes
• Completely safe; protection against overcharge, overheat, short-circuit, and
polarity reversal
• Renews most brands of batteries
INSTRUCTIONS
1.One single battery cannot be charged. Must have at least two batteries in unit.
Different size batteries can be renewed at the same time.
2. Place batteries in Renu- It with polarity as indicated. Plug into outlet. The LED
light on the left will show green to indicate power to the unit.
3. The LED light on the right will show red while renewing (in average 24 hours).
When red LED blinks green, it denotes that the battery is renewed. If the red LED
does not go green within an 24 hour period, then the battery cannot be renewed.
4. Remove the batteries from the unit once they are renewed and enjoy.
ONLY ONE BATTERY CHEMISTRY CAN BE CHARGED AT A TIME
Do not charge alkaline with Ni-Cd,
Alkaline with Ni-MH, or Ni-Cd with Ni-MH
Status indicator-
Red will indicate that batteries are
charging.
Green (blinking) indicates that
batteries are fully charged.
Power indicator-
Will show green to
indicate that the unit has
power.
(note: Unit will automatically shut o after 24 hours of being
plugged in. To turn back on, unplug and plug back in)
RENU-IT
TM
BATTERY COMBINATIONS
These battery
combinations
will work in
the RENU-IT
These battery
combinations
will not work in
the RENU-IT
4 of
same size
2 of same
size-left
2 of same
size-right
2 of same
size on
each side
2 of same
size plus
9v
1 or 2
9v
1 AA or
AAA only
AA & AAA
in same
circuit
AA & AAA
in same
circuits
FRONT BACK