User's Manual Part 1

Chapter 3 Testing
Assessing WiFi performance throughout a site
WiFi Advisor Wireless LAN Analyzer User’s Guide
December 2014 22073751, Rev. 002 Page 29
4 If you wish to change the profile, do the following:
a In the Test Profile box, just above the network graphic, enter a name for
the profile.
b Touch the instrument graphic on the left to specify the device that is oper-
ating as the access point.
i Do one of the following:
- Select from the pre-defined devices that is operating as the access
point.
- If no pre-defined configuration matches your needs, touch Add AP
Device.
ii Specify settings for the device, such as standard, band, channel
width, number of antennas, and other configuration items.
c Touch the instrument graphic on the right and specify the device that is
operating as the Station.
i Do one of the following:
- Select from the pre-defined devices that is operating as the access
point.
- If no pre-defined configuration matches your needs, touch Add
Station Device.
ii Specify settings for the device, such as name, standard, number of
antennas, and other configuration items.
d Just above the instrument graphic on the left, select Layer 1/2 Thresh-
olds.
i Specify the Layer 1 Thresholds for RSSI, Noise, count of BSSID’s
on a Channel, and count of BSSID’s with Overlapping Channels.
ii Specify the Tx Failures, Retransmits, PHY rate, and Service
Threshold for the 802.11 Thresholds.
iii Touch the back arrow to return to the new configuration page.
5 If you wish to specify another Primary Profile, touch Add Profile located
under Primary Profiles.
6 If you wish to include a Secondary Profile, move the button to Enable and
follow
step 4 above.