User's Manual Part 1

Appendix A Maintenance and Specifications
Charging the battery
WiFi Advisor Wireless LAN Analyzer User’s Guide
Page 44 22073751, Rev. 002 December 2014
Charging the battery
When the Batt LED lights red, the battery pack should be charged or replaced.
To charge the battery
1 Connect one end of the AC adapter to the connector on the back of the WiFi
Advisor.
2 Connect the other end of the AC adapter to an AC power supply.
3 Let the WiFi Advisor charge for 5 hours for a fast charge; for maximum
capacity, allow the WiFi Advisor to (trickle) charge overnight.
The charging time will be the same whether the power is on or off.
The Batt LED is amber when the unit is fast charging. The WiFi Advisor will
trickle charge at other times when the charger is connected and the Batt LED
is green.
After the Batt LED turns green (fast charge is complete), allow the unit to
trickle charge overnight for maximum performance.
Charging the battery pack is complete.
Replacing the battery pack
The battery compartment is located on the bottom of the unit.
The following procedure describes how to replace the battery pack.
NOTE:
You can test a circuit and recharge the battery at the same time. If you do not want to
interrupt the current test, you may leave the power on and connect the AC power
adaptor.
WARNING: ELECTRICAL SHOCK
Electrical shock may result in serious injury or death. Be sure the AC Adapter is con-
nected to the correct voltage mains. Do not use outdoors or in wet locations. Use
only the AC Adapter supplied with the test set.