Getting Started Guide
Table Of Contents
Important Safety Instructions
Safety Instructions – ONA-800 Base Unit
April 2020 22142810, Rev 001 Page 4
minimum of 0cm from the body. CAUTION: This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
16. Use appropriate cables when connecting to telecommunications circuits. Putting an RJ-11
connector in a RJ-45 port can damage the RJ45 port.
17. WARNING: Danger of extreme heat, fire, or explosion if battery is tampered with. Replace only with
Viavi approved Li-ION battery. Dispose of used batteries according to the manufacturer's
instructions.
18. WARNING: Charge the lithium ion battery using only the Viavi instrument or approved battery
charger. The battery is to be used only with Viavi test products.
19. Only trained telecommunications technicians who understand the hazards associated with TNV
lines and practice proper procedures for dealing with TNV should use this tester.
20. Be sure that TNV signals are not connected to SELV ports. If you need to access a line that may
have TNV or higher voltages present using a SELV port, you must do so through an interface
device that is certified to provide a SELV connection point.
21. CAUTION: When equipped with laser modules supplied by Viavi, this instrument will be a CLASS 1
LASER PRODUCT. Class 1 lasers can cause dazzle, flash-blindness, and afterimages. Avoid
looking into laser output while performing safety critical operations, such as climbing on a ladder or
operating machinery. Do not use laser modules of other classes.
22. Please see “Safety symbols” for safety symbols. Where the unit is labeled with a warning symbol,
the operating manual must be consulted to learn more about the nature of the potential hazard and
any action that must be taken.
Save these instructions