User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 5 Optical Tools
About the optical tools
84 T-BERD/MTS 5800 Getting Started Manual
About the optical tools
Two USB optical accessories are available for the
T-BERD ⁄ MTS 5800.
– Fiber Microscope
– Inspect both the bulkhead (female) and patch cord
(male) sides of fiber interconnect as well as optical
devices located in hard-to-reach places (transceivers).
– Inspect both simplex connectors.
– Use with a comprehensive selection of precision FBPT
tips.
– Optical Power Meter
– Takes power measurements for all single-mode and
multi-mode connectors via USB 2.0 connection.
– Measures optical power with multiple pre-calibrated
wavelengths (850, 980, 1300, 1310, 1490, 1550 and
1625 nm).
– Integrates digital power measurements, fiber inspec-
tion, and analysis into a single, unified work sequence.
Inspecting fiber
The JDSU fiber microscope accessory is used to view a live
video of a simplex fiber to determine if the fiber is clean. It can
also capture a snapshot and provide pass/fail analysis.
To inspect fiber
1 Connect the fiber microscope to a USB connector on the
right side of the instrument.
A MicroScope icon appears in the title bar.
2 Select the MicroScope icon.
The Fiber Microscope screen appears.