User's Manual

Chapter 6 Maintenance and Troubleshooting
Maintaining the battery
90 T-BERD/MTS 5800 Getting Started Manual
Pinch the wipe firmly with your fingers, and then twist
the ferrule. Repeat this process three times, using a
clean area of the wipe each time. Clean the tip and as
much of the outside of the ferrule as possible.
c To dry the ferrule tip, press it into a clean, dry spot of
the wipe, pinch, and then twist one time.
d Discard the used wipe.
e Optional. Use the compressed air can to remove
tissue fragments that may have been deposited on the
tip of connector.
3 If you are cleaning the connector using the CLETOP reel
type cleaner, do the following:
a Press the lever on the left of the CLETOP reel up to
expose the cleaning tape.
b Place the top of the connector squarely at the top of
the exposed cleaning tape.
c Rotate the connector clock-wise, and then counter
clock-wise.
d Swipe the connector down to the bottom of the
exposed tape.
e Release the lever on the CLETOP reel to cover and
protect the cleaning tape.
4 Inspect the ferrule. If it is still dirty, repeat step 2 or step 3.
The cable connector is clean.
Maintaining the battery
This section discusses troubleshooting and maintenance
information related to the T-BERD ⁄ MTS 5800’s rechargeable
lithium-ion battery.