User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 6 Maintenance and Troubleshooting
Upgrading the software
T-BERD/MTS 5800 Getting Started Manual
95
2 Select the SYSTEM icon.
3 Select System Info.
4 Click in the New Option Key field. A keyboard appears.
5 Enter the unique number key that was provided by
Customer Service, and then select OK.
6 Select Install to add the option.
When the menu is viewed again, a check mark appears next
to the option indicating it is available for use.
Upgrading the software
The T-BERD ⁄ MTS 5800 software can be upgraded in the
field using either the 10/100/1000 Ethernet port or the USB
port on the side panel of the instrument.
The process for updating varies depending on the way the
update is performed.
Updating over a
network
To update over a WAN
1 Select the SYSTEM icon.
2 Select Upgrade.
3 Select Network.
4 Obtain the FTP address where the software file is located,
as well as the User Name and Password.