User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 6 Maintenance and Troubleshooting
Upgrading the software
96 T-BERD/MTS 5800 Getting Started Manual
5 Connect the T-BERD ⁄ MTS 5800 to the AC charger
adapter to ensure an uninterrupted supply of power
during the update.
6 Specify the server hostname.
7 Select Connect.
The version information is displayed.
8 Select Start Upgrade.
A dialog box appears directing you to exit any existing
tests.
9 Select OK.
The unit reboots when done.
Updating using
USB Flash
To update over USB
1 Connect the T-BERD ⁄ MTS 5800 to the AC charger
adapter to ensure an uninterrupted supply of power
during the update.
WARNING: ELECTRICAL SHOCK
Electrical shock may result in serious injury or death. Be
sure the AC adapter is connected to the correct voltage
mains. Do not use outdoors or in wet locations. Use only
the AC adapter supplied with the tester.
NOTE:
The update will typically take 15 to 30 minutes, depending
on the speed of your network.
WARNING: ELECTRICAL SHOCK
Electrical shock may result in serious injury or death. Be
sure the AC adapter is connected to the correct voltage
mains. Do not use outdoors or in wet locations. Use only
the AC adapter supplied with the tester.