User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 6 Maintenance and Troubleshooting
Troubleshooting
T-BERD/MTS 5800 Getting Started Manual
97
2 Connect a USB flash drive to the USB connector on the
top panel.
3 Select the SYSTEM icon.
4 Select Upgrade.
5 Select USB.
6 Select Start Upgrade.
A dialog box appears directing you to exit any existing
tests.
7 Select OK.
The unit reboots when done.
Troubleshooting
If you experience problems using your instrument, you may be
able to solve these problems on your own after referring to this
section. If you experience significant problems with the instru-
ment, call the Technical Assistance Center (see “Technical
assistance” on page xx).
Setup
The following issues may arise when setting up the instru-
ment.
Which transceivers
are compatible
with the
instrument?
A list of JDSU recommended optics is available by selecting
the corresponding option from the Help menu on the user
interface of your instrument. You can also see detailed infor-
mation for the currently inserted SFP or XFP on the Interface
setup tab of the user interface.
NOTE:
The update will typically take 15 to 30 minutes.