User's Manual

Chapter 6 Maintenance and Troubleshooting
Troubleshooting
98 T-BERD/MTS 5800 Getting Started Manual
No signal is
detected when
running 10 GigE
application
There are several reasons why a signal may not be detected:
– Verify that the XFP transceiver is properly inserted.
– Turn the laser OFF, and then ON again.
Operating the
instrument
The following issues may present themselves when operating
and performing basic functions using your instrument.
How much space
is available for my
data?
There is roughly 1 GB of space available for storing data such
as reports.
Instrument will not
power up
There are several reasons why the instrument may not be
powering:
– Check the power source and restart the instrument.
– If the instrument is running on the power adapter, verify
that the power source is adequate.
– Unplug the power adapter. Remove the battery, and then
reconnect the battery. Plug in the power adapter, and then
turn the instrument ON.
Performing
tests
The following section addresses questions that may be asked
about completing tests with the instrument.
Application does
not appear on the
Test menu
Ensure that the required test option is installed. For example,
if you are looking for MiM (PBT) applications, or if you do not
see the settings required to verify layer 2 transparency, verify
that you installed the associated test option.