User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Appendix A Specifications
Supported electrical Ethernet rates
T-BERD/MTS 5800 Getting Started Manual
105
Supported electrical Ethernet rates
The electrical Ethernet applications use the RJ-48 jacks.
Table 7 lists the electrical Ethernet rates supported.
Clock source (Timing) specifications
Table 8 lists internal and external timing specifications.
Table 7 Electrical rates
Rate Mbps
10Base-T Ethernet 10
100Base-T Ethernet 100
1000Base-T Ethernet 1000
Table 8 Timing specifications
Clock Source Description
Internal reference accuracy ±1.5 ppm, ±1 ppm per year aging
External BNC from BITS, SETS, or CLOCK
–BITS
1.544 Mbps DS1/T1 signal
– SETS
2.048 Mbps E1 signal
– 2MClock
2.048 MHz G.703 sync clock (square
wave)
– 10M Clock
10.000 MHz square clock